How to restore and protect a façade clad with single-coat mortars

Descripción sistema

Single-coat mortars applied on façades are exposed to external agents (rainfall, low temperatures, frost, fungus, humidity, saltpetre, pollution, etc.) that have a negative influence on their aesthetic durability.

Rainfall, low temperatures, frost, produce efflorescence.

Material subjected to continuous exposure to high ambient humidity leads to fungal growth.

The natural ageing of the façade causes the degradation of the single-layer mortars.

To restore the decorative appearance and at the same time protect the façade we use REVAT FILM SLX

Linked solutions

• APPLICATION OF SINGLE-LAYER MORTAR ON AERATED CONCRETE
• APPLICATION OF SINGLE-LAYER MORTAR ON THERMO-CLAY BLOCKS
• APPLICATION OF SINGLE COAT MORTARS ON SMOOTH SURFACES
• WHERE TO LAY FIBREGLASS MESH
• REALISATION OF SINGLE-LAYER COATING IN COLD OR WET WEATHER
• REALISATION OF SINGLE-LAYER COATING IN HOT WEATHER OR IN DRY WINDY CONDITIONS
• RENOVATION OF OLD FAÇADE CLADDING
• APPLICATION AND FINISHING SYSTEMS FOR SINGLE-COAT STONE
• APPLICATION AND FINISHING SYSTEMS FOR SINGLE-COAT SCRATCH COATINGS
• ACRYLIC MORTAR APPLICATION AND FINISHING SYSTEMS

Related products

• PROPAM DUR
• REVAT PROTEC ORG
• REVAT® FILM SLX
• PROPAM ANTI-FISSURE RENOVATION

Solution

PREPARATION OF THE SUBSTRATE

Verify the condition of the support by checking its strength.

Wash with pressurised water to remove all remains of the mortar surface (fungus, dust, paint residues, etc…).

On very absorbent and/or easily degradable substrates it is essential to apply a primer coat with PROPAM® DUR.

APPLICATION

Use REVAT® FILM, acrylic mortar to restore the aesthetic qualities of the single layer mortar and improve the protection of the façade.

In those areas where the material may be exposed to very extreme conditions (frequent rainfall, proximity to the sea, etc…) it will be necessary to apply a layer ofREVAT® PROTEC ORGas an additional protection measure for the façade.

Recommendations

• Do not apply in direct sunlight or strong wind.
• Do not apply when there is a risk of rain or frost.
• Apply between +5ºC and 35ºC temperature.
• Do not apply to areas submerged in water.
• Protect the lower parts of buildings with skirting boards.

• During application protect exposed areas from rain.
• If the monocoat has cracks, it can be treated with FLEXIBLE SYSTEM: PROPAM RENOVATION ANTI-CRACKING.
• In new single-layer building work and areas where the material may be exposed to extreme conditions (frequent rainfall, proximity to the sea, etc.) it will be necessary to apply a coat ofREVAT® PROTEC ORGas an additional protection measure for the façade and to prevent premature ageing.